Skip to content
First Aid

First Aid on Construction Sites: What Every Worker Should Know

By WhiteCard Prep Team · Last updated 8 min read

Construction sites are high-risk workplaces where injuries can happen despite the best safety measures. Knowing basic first aid can mean the difference between a manageable incident and a tragedy. This guide covers the first aid knowledge that every Australian construction worker should have, including legal requirements, kit contents, and step-by-step responses to the most common site injuries.

Important: This article is general information for study purposes and does not replace a first aid course. The first aid steps below follow the guidelines of the Australian and New Zealand Committee on Resuscitation (ANZCOR), which are used by Australian first aid training providers. In an emergency, call Triple Zero (000) and follow the operator's instructions.

Related practice questions

Our Fire Safety & Emergency Procedures topic includes questions on first aid, emergency response, and incident reporting.

Legal Requirements for First Aid

Under regulation 42 of the model WHS Regulations, a PCBU must ensure workers have access to first aid equipment and facilities, and that an adequate number of workers are trained to give first aid (or that workers can access trained first aiders). Regulation 43 requires an emergency plan for the workplace. The model Code of Practice First aid in the workplace gives practical guidance on meeting these duties. For construction sites, this generally means:

  • First aid kits: At least one first aid kit should be provided and easy for all workers to reach. Large or spread-out sites may need several
  • Trained first aiders: First aiders should hold a current nationally recognised first aid qualification, such as HLTAID011 Provide First Aid. The Code suggests starting ratios of one first aider for every 25 workers at high-risk workplaces (which includes most construction sites), one for every 50 at low-risk workplaces, and one for every 10 at remote high-risk workplaces. The PCBU should adjust these to the actual risks
  • First aid room: Regulators' guidance based on the Code recommends a first aid room for high-risk workplaces with 100 or more workers (200 or more at low-risk workplaces), or where a risk assessment shows one is needed
  • Emergency plan: The emergency plan must set out emergency procedures, including an effective response, evacuation, notifying emergency services and medical treatment. It is good practice to include the site address and directions for emergency services
  • Signage and information: Workers should be told, usually at induction, where the first aid kits are, who the first aiders are and how to get help. Signs are commonly used to show this

Victoria: Victoria does not use the model WHS Regulations. Employers there have first aid duties under the Occupational Health and Safety Act 2004, and WorkSafe Victoria's First aid in the workplace compliance code (2021) explains how to meet them.

Construction Site First Aid Kit Contents

The model Code of Practice lists recommended contents for a workplace first aid kit and suggests adding extra items for specific hazards. A construction site kit is usually more comprehensive than an office kit. Typical contents include:

  • Adhesive dressings (various sizes) and wound closure strips
  • Sterile gauze pads and non-adherent dressings
  • Conforming and crepe bandages
  • Triangular bandages (for slings and immobilisation)
  • Heavy-duty wound dressings for serious bleeding
  • Eye wash solution (saline) and eye pads
  • Burn dressings (hydrogel type, not for chemical burns)
  • Splints for suspected fractures (optional, based on risk)
  • Disposable gloves, face shield for CPR, safety pins, scissors, and tweezers
  • Instant cold packs
  • Emergency thermal blanket
  • First aid instruction booklet

The kit must be regularly checked to ensure supplies are stocked and within their expiry dates. Assign a responsible person to maintain the kit.

Common Injuries and First Aid Response

Cuts and Lacerations

Cuts from sharp materials, tools and machinery are common on construction sites.

  • Put on gloves if available, then apply firm, direct pressure on the wound with your hands or a pad. ANZCOR identifies this as the most effective way to control most bleeding
  • Have the casualty lie down and keep still, and keep a bleeding limb still
  • If bleeding continues, add another pad and a firmer bandage, and check the pad is directly over the bleeding point
  • ANZCOR no longer recommends raising (elevating) a bleeding limb, because there is no evidence it helps and it can cause pain or further injury
  • Do not remove embedded objects, as they may be plugging the wound. Pad on each side of the object and apply pressure over the padding
  • For life-threatening bleeding from a limb that direct pressure does not control, a trained first aider may apply an arterial tourniquet. Note the time it was applied
  • If bleeding is severe or cannot be controlled, call 000 immediately

Fractures and Crush Injuries

Falls, struck-by incidents, and machinery contact can cause fractures and crush injuries.

  • Do not move the casualty unless they are in immediate danger
  • Immobilise the injured area using a splint or by strapping the injured limb to the body
  • A wrapped cold pack can help with pain and swelling (do not put ice directly on skin)
  • For suspected spinal injuries, keep the casualty completely still and call 000
  • For crush injuries, call 000. ANZCOR advises removing the crushing force as soon as it is safe and physically possible, whatever the length of time the person has been trapped. Older advice to leave a long-trapped limb in place is no longer recommended. Watch the casualty closely after release, because crush syndrome can affect the heart and kidneys

Eye Injuries

Foreign objects, dust, chemical splashes, and UV exposure cause eye injuries on construction sites.

  • For loose dust or particles: gently flush the eye with clean water or sterile saline
  • For chemical splashes: immediately flush the eye with running water, holding the eyelids open, and get urgent medical attention. ANZCOR's burns guideline recommends flushing chemical burns for at least 20 minutes. Check the Safety Data Sheet (SDS) and call the Poisons Information Centre on 13 11 26 for advice
  • Do not rub the eye or attempt to remove embedded objects
  • Cover the injured eye with a sterile pad and seek medical attention

Burns

Hot work (welding, cutting), electrical faults, chemical contact, and sun exposure cause burns.

  • Cool the burn under cool running water for at least 20 minutes. Start as soon as possible, but cooling still helps if started up to 3 hours after the burn
  • Remove jewellery and any clothing that is not stuck to the skin. Do not peel off anything stuck to the burn
  • Cover loosely with a non-stick dressing or clean cling film laid over the burn (not wrapped around a limb, and not on the face or on chemical burns)
  • Do not use ice or iced water, and do not apply creams, lotions, ointments or powders. Do not break blisters
  • For chemical burns, protect yourself, brush off any powder, remove contaminated clothing, then flush with running water for at least 20 minutes. Check the SDS and call the Poisons Information Centre (13 11 26)
  • Call 000 for any significant burn, including burns to the face, hands, feet, genitals, buttocks or major joints, electrical or chemical burns, burns with breathing problems or smoke inhalation, burns that go all the way around a limb or the chest, large burns (about 10% of the body, roughly an adult's whole arm), or if you are unsure

Heat Stroke Response

Heat stroke is the most serious form of heat-induced illness and is a medical emergency. It happens when the body can no longer control its temperature. Without rapid cooling and medical treatment it can cause organ damage and death.

Warning signs (ANZCOR): being unable to keep working, high body temperature, dizziness or faintness, nausea, vomiting or diarrhoea, pale skin or other signs of shock, weakness or poor coordination, and confusion, reduced consciousness or seizures. Some people with severe heat illness stop sweating and have dry skin, but not all do.

  • Call 000 immediately
  • Move the casualty to a cool, shaded place and loosen or remove excess clothing
  • Cool them as quickly as possible without delaying the ambulance call. The most effective method is immersing them in cold water up to the neck for about 15 minutes
  • If immersion is not possible, combine methods: wet the skin with cool water (shower, hose or wet cloths), keep re-wetting it, fan continuously, and apply cold packs to the groin, armpits, cheeks, palms and soles of the feet
  • Only give drinks if the casualty is fully conscious and able to swallow. Give cool water, or a sports drink for dehydration from heavy work
  • Monitor breathing and be prepared to start CPR if the casualty becomes unresponsive

Snake Bite

Construction sites in rural and semi-rural Australia β€” and even some urban sites β€” may encounter venomous snakes. Australia has some of the most venomous snakes in the world.

  • Call 000 immediately
  • Keep the casualty still, calm and under constant observation. Movement helps venom spread through the lymphatic system
  • Apply the pressure immobilisation technique (ANZCOR Guideline 9.4.8). First apply a broad pressure bandage (ideally an elasticised bandage 10-15 cm wide) over the bite site as soon as possible. Then, starting at the fingers or toes, bandage firmly up the limb as far as you can reach, covering the bite. It should be firm enough that you cannot easily slide a finger under it. It is not a tourniquet
  • Splint the limb, including the joints above and below the bite, and keep the person completely still. Bring the ambulance to them rather than walking them out
  • Do not remove the bandage or splint. Hospital staff will do this
  • Do NOT wash the bite site, because venom left on the skin can help with testing at hospital
  • Do NOT cut the bite, suck the venom, or apply an arterial tourniquet. Do not try to catch or kill the snake
  • Monitor breathing and be ready to perform CPR. ANZCOR notes that sudden collapse can occur after a bite

Electrocution

Electrical contact can cause cardiac arrest, severe burns, and falls from height.

  • Do NOT touch the casualty until you are certain the power source is disconnected. Turn off the power at the source or use a non-conductive object to separate the casualty from the electrical source
  • Call 000 immediately
  • If the casualty is unresponsive and not breathing normally, begin CPR immediately
  • Anyone who has had an electric shock should be assessed by a doctor, even if they seem fine, because internal burns and heart rhythm problems may not be obvious straight away. Electrical burns are always treated as significant burns
  • Treat any burns with cool running water as described above

When to Call 000

Call Triple Zero (000) immediately for:

  • Unresponsiveness or loss of consciousness
  • Difficulty breathing or not breathing
  • Chest pain or suspected heart attack
  • Severe bleeding that cannot be controlled
  • Suspected spinal injury
  • Heat stroke
  • Snake bite
  • Any electrical shock
  • Seizures
  • Severe allergic reaction (anaphylaxis)
  • Falls from height with any injury
  • Crush injuries where the limb has been trapped

When calling 000, stay calm and provide: the site address, the nature of the injury, the number of casualties, and what first aid has been given. Stay on the line until the operator tells you to hang up.

Key Takeaways

  • Every construction site must have first aid kits, trained first aiders, and an emergency plan
  • Cool running water for at least 20 minutes is the recommended first aid for burns, and chemical splashes need prolonged flushing with water
  • Heat stroke is a life-threatening emergency. Call 000 and start cooling straight away
  • For snake bites, call 000, apply the pressure immobilisation technique and keep the casualty still
  • For crush injuries, remove the crushing force as soon as it is safe to do so
  • Never touch an electrocution casualty until the power is confirmed disconnected
  • When in doubt, call 000. It is always better to call and not need help than to delay and lose a life

Sources and further reading (last reviewed November 2026)

WHS rules differ between states and change over time. Where this page states a legal or regulatory fact, it is based on the official sources below. If anything here disagrees with them, the official source wins. You can read how we check and correct our content.

Test Your Emergency Knowledge

Practice first aid and emergency procedure questions for your White Card.

Start Practice Test

This guide is free and kept up to date by one person. β˜• Support it